MPS Quick Reference Guide
Scan Track establishment
More more information, refer to Appendix 2 of the MPS Operator Manual here.
Scanner alignment
- Main Screen > Select System > P/W TALLY
[…]
MPS Installation Quick Start Guide
Step 1. Mounting the kiosk
The kiosk is the central point of the system and contains the operator touch panel and power connections. It needs to be firmly mounted in a suitable […]
Appendix 2 – Scan Head Installation and Alignment – Operator Manual – MPS-3 Series Rev1
The following procedures must be carried out every time an MPS is installed in a new location.
These procedures must be performed to correctly install and align the scan head and define the […]
User Configuration Options – Operator Manual – MPS-3 Series Rev2
The Settings screen (figure 19) provides options for customising the MPS configuration.
Access this screen from the SETTINGS button on the Main screen. The ‘system’ password is required.
Figure 19 – […]
Load Status Reporting – Operator Manual – MPS-3 Series Rev2
Introduction
When load status reporting is enabled, status values are reported for each measured load.
Load quantity status values indicate whether the bin is:
- loaded correctly (with the expected quantity of material)
- underloaded
- overloaded.
Load distribution status […]
Basic Operation – Operator Manual – MPS-3 Series Rev2
This section describes basic operation of the MPS after installation and commissioning.
Starting up and shutting down
Use the power isolator switch on the front of the power box to power on […]