The following procedures must be carried out every time an MPS is installed in a new location.
These procedures must be performed to correctly install and align the scan head and define the […]
The Settings screen (figure 19) provides options for customising the MPS configuration.
Access this screen from the SETTINGS button on the Main screen. The ‘system’ password is required.
Figure 19 – […]
Introduction
When load status reporting is enabled, status values are reported for each measured load.
Load quantity status values indicate whether the bin is:
Load distribution status […]
This section describes basic operation of the MPS after installation and commissioning.
Starting up and shutting down
Use the power isolator switch on the front of the power box to power on […]